FAQ

Q1: What devices can the Explorer 1000 power?

A: The Explorer 1000 can charge/power devices that operate at less than 1000 watts. It’s important to note that the total wattage of all connected devices should also be under 1000 watts. If the power requirement exceeds this limit, the Explorer 1000 will automatically shut off. Please check your device’s specifications before making a purchase.

Q2: How can I know the working time for my device?

A: You can calculate the working time using the formula: Working time = 1002Wh*0.85/operating power of your device. For example, if the power consumption of your device is 60W, the estimated working time would be approximately 14.2hrs. Please note that actual power consumption may vary based on different usage scenarios.

Q3: What is the maximum wattage of solar panels that can be used to charge the Explorer 1000? Also, how long will it take to recharge from a fully discharged battery?

A: The Explorer 1000 has a maximum input wattage of 126W (12-30V, 7.5-8.33A). As to the recharging time, it depends on the solar panel you are using and the prevailing weather conditions. For example, if you connect two SolarSaga 100W solar panels together with an adapter cable, you can quickly recharge the Explorer 1000 within 6 hours. However, if you’re using a single panel, the approximate recharging time is around 13 hours. It’s important to note that recharging time may vary based on factors such as location, temperature, and weather conditions, so the actual time may differ.

Q4: Can the Explorer 1000 be charged while in use?

A: Yes, you can use the Explorer 1000 to charge devices while it is being recharged at the same time.